Hova bator manual






















The Hova-Bator is designed for simplicity in this matter, and works well for most species. MoIStUre veNt PlUG A red vent plug is located on the top of the incubator. This should be removed when the incubator is used at altitudes greater than . the Hova-Bator from closing properly. On Volt models, attach the plug required by your country. All units must be connected to a grounded (earthed) outlet via a 3 prong grounded male plug. Manual Before Using This Device GOOSE LARGE CHICKEN EGG RACK LAYOUT For Goose and Large Chicken eggs use the (5) rack position layout. Thermal Hova-Bator www.doorway.ru Sign In. Whoops! There was a problem previewing Thermal Hova-Bator www.doorway.ru Retrying.


Moisture in the Hova„Bator is controlled by putting water in the small inner trough of the bottom. The small trough by itself will increase the humidity to take care of most climates. If you live in an extremely dry climate you may need moisture in the larger outer trough instead of the smaller trough. During time. We finally bit the bullet and bought our own incubator. Now we have no excuses! We'll be hatching birds all over the place LOL Not really, we'll try to contr. Click here to purchase the Thermal Air Hova-Bator Incubator. Please click on the attachment to view the product manual.


Moisture in the Hova„Bator is controlled by putting water in the small inner trough of the bottom. The small trough by itself will increase the humidity to take care of most climates. If you live in an extremely dry climate you may need moisture in the larger outer trough instead of the smaller trough. During time. Hova-Bator Bottom. Arrange the plastic floor as shown using the water troughs and turner power cord notch as reference. Fill Center trough (highlighted) with warm water. Surface area, not depth, effects humidity; refill trough as necessary to prevent it from drying out. Place the top over the bottom. HOVA-BATOR Thread wafer onto adjusing screw till it stops, then with incubator plugged in turn adjusting screw counterclockwise until light comes on and then 4 additional turns. Allow the temperature to stabilize and then adjust as needed.

0コメント

  • 1000 / 1000